Scroll down to see more information about our Step Irons?

RMCS Step Irons

RMCS Step Irons are used in sewers, drainage manholes or pits. Our step irons are manufactured from high strength steel bar and are fully encapsulated in tough yellow polypropylene for visibilty underground. There are no sharp edges or corners on these step irons and the 25mm sides stop feet slipping off.

RMCS step irons are resistant to corrosion from acids, alkalis and chemicals. Load strength is greater than 3.6kn and they have a pull-out strength of 1.8kn. They can be set into pre-cast structures during concrete pour, caulked into a drilled hole with epoxy resin or fixed with quick setting cement.



STEP IRON PRODUCT CODES AND SIZES:

Product
Product
Width
Length
Thread
Code
Applicationt
mm
mm
Length mm
SI1
Brickwork
150mm
185mm
70mm
SI2
Conctrete
150mm
185mm
50mm
SI3
Fibre
150mm
160mm
30mm

Rebar, Mesh and Construction Supplies (Pty) Ltd is the number one supplier of accessories, specialised tools and equipment to the construction industry in Africa. We carry a large variety of rebar spacers, rebar cutters and benders, lifting equipment, safety netting, rubble chutes, brick baskets, daga mixing trays, waterproofing membranes, joint formers, shutter strip formwork joint sealer, K-Form screed rails and much, much more. Browse our website and you will be surprised to see what products we offer to make your job a lot easier on site.


Products from Rebar, Mesh and Construction Supplies (Pty) Ltd have been used in some of the largest projects in South Africa and the African Continent.


Construction Accessories Menu

Take 30 seconds and watch the videos here below to get a quick insight of the range of products that manufacture or distribute?